A garage door is made up of two main components: the door itself and the opening mechanism, or opener. By understanding which component is malfunctioning, you can get a more accurate estimate on what it will take to make the repair. You will also know what your specialist on garage door repair in Seatlle should be doing for you.
Door Components
Tracks: Whether your overhead garage door swings up in one piece or has sections that roll up, it operates on spring tension. There are metal tracks on the garage walls or on the ceiling and one or more heavy springs provide the power.
Springs: One of the first things you can do is check the metal tracks to determine whether they are loose. A loose track may simply need to have the screws or bolts tightened. Your repairman should close the garage door and check for crimps, dents, or flat spots in the track and repair any damaged spots. If the tracks have a lot of damage and can’t be repaired, they should be replaced.
Hardware: Be sure to ask your repairman if he checked the track alignment with a level and verified that they are at the same height on each side. He should also clean the tracks to eliminate old dirt or grease and then lubricate them so that the doors can move smoothly on the tracks. Your specialist for garage door repair in Seatlle should check for loose hardware, particularly at the hinges and the springs. On a swing-up door, you want to check where the spring is mounted to the plates and make sure that the screws are tight, and on the roll-up doors, you should make sure the hinges that hold each section of the door are tight and not damaged.
Opener Components
Drive Mechanism: It is also important that he check the garage door opener for problems and repair or replace it as needed. He should verify that the drive mechanism is properly attached as well as looking at the radio receiver to be sure it is connecting properly.
Radio Receiver: The radio receiver is the part of the opener that receives the signal from your remote control. If the receiver is damaged, your remote control will not work. The repairman should check the receiver for any signs of damage, such as loose wires or corrosion.
